MINARELLI V1 SCOOTY KIT SPACER 22.8

When normal moped kits aren't enough and you want to push your V1 engine to the limit, this wild spacer from Moped Factory will let you bolt a cylinder-reed Minarelli Vertical Scooter cylinder from 90's BWS/Booster/Zuma (etc) directly on to the V1. 

This is definitely for pros only, the piston pin on the scooter is 10mm vs 12 on the v1, the piston might hit the cases, and there is very likely some porting and adjustment needed since the Scooter is a 40mm stroke and the V1 is 42. 

Check out the thread here on Moped Army for a full discussion... IYKYK as the kids say.  This is the 22.8 MM spacer that should put you right around TDC with the right gaskets. 

https://www.mopedarmy.com/forums/read.php?7,4514337